665 Leather Neoprene and Fetish Clothing: Lucifer's Ladder Red

SKU: 23281 Lucifer's Ladder Red

Description

The first is the double loop designed to insulate the base electrode going around your cock and balls.

This design was created to act as a sort of splint to help growers and shrinkers to not have to worry about their shaft electrodes coming into contact with each other.

Here is Lucifer's Ladder, and it allows you to place the two front loops in any of the holes in the ABS body of this electrode holder.

My suggestion would be to use the two outer loops on one channel to stim the Dorsal and Perineal nerve groups.

It's recommend using the middle loop in conjunction with the tip of an anal electrode. Something like the Moaner or Large Flo would be perfect, but even a monopole pad electrode placed behind your anus would work well too.

Not into the spikes? Check out the Stairway To Heaven Electrode.

This electrode holder is made from ABS (think Lego plastic); it's hard-wearing, non-porous and doesn't need painting or any other finish. If you prefer the best, then this is the version for you. They will be available in very limited quantities, so grab one while you can.

This cock loop holder is printed in ABS. This holder has three generous lengths of 6mm conductive rubber tubing that can be trimmed to suit your anatomy. The high-quality British CR takes a 2mm plug.

It will be dispatched with the three 6mm conductive rubber tubing loops already fitted.

Dimensions

1 x 33cm/13" Base Loop.
2 x 25cm/10" Shaft Loops.

Care Instructions

Material

This product is 3D printed in ABS, a very strong plastic with excellent mechanical properties. Once printed I post-process the components using a procedure called vapour smoothing. This uses Acetone vapour to melt and smooth the surface of the prints turning them from rough prints into smooth, shiny prints that are non-porous.

Porosity is one drawback of the 3D printing process as it leaves microscopic holes in the surface of prints that are perfect for bacteria to grow in and hard to clean. Vapour smoothing prints seals these tiny holes and imperfections, leaving the products smooth and sealed.

This is important as it makes cleaning post-play so much easier.

Product Care

After play, simply wash in warm soapy water. Anti-bacterial soap is best. Once body fluids have been washed off, allow the electrode to dry thoroughly before you store it away for later use.

A deep clean can be carried out using Isopropyl Alcohol, and this will kill bacteria and remove body oils.

Never use silicone-based lubes with conductive rubber-based electrodes as the silicone will bond to the conductive rubber, effectively destroying it and insulating it.

How To Use

Just slip it over your cock and tighten it before plugging your 2mm plug into the CR.